I see what the problem is... nano /etc/fstab is displaying none of the devices from the disk I just installed it to. Instead it's showing me the USB drive's fstab:
devpts /dev/pts gid=5,mode=620 0 0
proc /proc defaults 0 0
tmpfs /dev/shm defaults 0 0

It won't allow the mounting of /dev/mmcblk0p3 ...

Because nothing was working to fix the problem I reinstalled Salix and eth0 works but slapt-get --update won't work (response: "slapt-get: error while loading shared libraries: libcurl.so.4: cannot open shared object file: No such file or directory") nor will wget (similar response), but ping google ...

djemos - I was not aware of needing to run /sbin/grubconfig and that may very well be the cause of the problem. Grub is easier with Debian based systems (which almost always use it as the default bootloader anyway) and very few steps are required. djemos - I certainly did run update-grub (a number ...

Darn... Grub's in but still won't boot (even after using Boot Repair from a Ubuntu Mate 16.04 64-bit USB).
https://drive.google.com/file/d/0B-1lAPlHMTDgQ0poeWhzTGFUSzg/view?usp=drivesdk
Image won't display above (too large I suppose)... Here the link to it at least https://drive.google.com/file/d ...

There we go! Found 2nd 1/2 of solution here: https://www.linux.com/learn/intro-slackware-package-management where it informed me of "slap-get" where I updated then upgraded existing packages, then "slapt-get --install grub" installed grub2. Now my system should be bootable.
All thanks to Mimosa for ...

I cannot boot the GizmoSphere Gizmo 2 without a Windows or Grub bootloader. The command "install-grub" does not work, even if Grub has been downloaded and install of as much attempted.
I cd'd to /grub2/, then chmod +x (all of the files within that directory excluding "README") but "install-grub" and ...

This was response to maximus, but the quote disappeared...
I had been repeatedly shown an ip address, netmask and broadcast address in response to ifconfig, but ping (you might consider adding "Press Ctrl + C to stop the pinging if you are provided responses) provided no responses and wget did not ...

How do I enable the DHCP eth0 network connection so that I can download grub2? Setup your wired network using netconfig
$ sudo netconfig
This will bring up a ncursers dialog box to setup your network

I followed the slackware page for setting up eth0 function seen here: https://docs.slackware ...

This was response to mimosa, but the quote disappeared...
ifconfig -a = etho

dhcpcd eth0=

"eth0: IAID (my MAC address displayed)

eth0: soliciting a DHCP lease

eth0: offered 192.168.1.101 from 192.168.1.1

eth0: probing for all IPv4LL address

eth0: leased 192.168.1.101 for 86400 seconds

eth0 ...

Hello all,
My name is David and I have been attempting to install Salix XFCE 14.2 64 bit on my Gizmo 2 SBC (Single Board Computer) but it requires the use of Grub, as Lilo fails to install every time. I have tried the steps for install of Grub during OS installation, but it always responds to "grub ...