OK, here are my new lilo.conf entries:mimosa wrote:Just put sudo in front of it.
Regarding lilo.conf, it occurs to me you may as well uncomment the original stanza again. You will then be able to choose at boot whether to boot with or without the initrd, making an easy fallback if needed. Make sure the 'label' lines are different, and preferably informative.
Code: Select all
# Linux bootable partition config begins
image = /boot/vmlinuz
root = /dev/sda1
label = Salix (original)
read-only
# Linux bootable partition config ends
# Linux bootable partition config begins
# This config was generated by mkinitrd_command_generator.sh
image = /boot/vmlinuz-huge-4.4.118
initrd = /boot/initrd.gz
root = /dev/sda1
label = Salix (generated)
read-only
# Linux bootable partition config ends
Code: Select all
sudo mkinitrd -c -k 4.4.118 -f ext4 -r /dev/sda1 -m xhci-pci:ohci-pci:ehci-pci:xhci-hcd:uhci-hcd:ehci-hcd:hid:usbhid:i2c-hid:hid_generic:hid-cherry:hid-logitech:hid-logitech-dj:hid-logitech-hidpp:hid-lenovo:hid-microsoft:hid_multitouch:jbd2:mbcache:ext4 -u -o /boot/initrd.gz
----
Success! Many thanks mimosa