Hello all, I've been away from salix a couple of years. I just installed 14.2 last night. Problem is, my system keeps freezing up. The wired connection takes several minutes to settle down and work, but one annoyance at a time. I've googled this and the only thing I've come close to my problem was a video driver problem. What do ya'll think? It runs fine for a while then starts this sh*t! It's not over heating. I really don't know were to begin. This is what's under the hood.wally[~]$ sudo lshw -short
Password:
H/W path Device Class Description
=============================================
system System Product Name (To Be Filled By O.E.M.)
/0 bus M5A78L-M LX3
/0/0 memory 64KiB BIOS
/0/4 processor Athlon II (To Be Filled By O.E.M.)
/0/4/5 memory 384KiB L1 cache
/0/4/6 memory 1536KiB L2 cache
/0/26 memory 4GiB System Memory
/0/26/0 memory 2GiB DIMM Synchronous 1333 MHz (0.8 ns)
/0/26/1 memory 2GiB DIMM Synchronous 1333 MHz (0.8 ns)
/0/100 bridge RS780 Host Bridge
/0/100/2 bridge RS780 PCI to PCI bridge (ext gfx port 0)
/0/100/2/0 display NVIDIA Corporation
/0/100/2/0.1 multimedia NVIDIA Corporation
/0/100/4 bridge RS780/RS880 PCI to PCI bridge (PCIE port 0)
/0/100/4/0 eth0 network QCA8171 Gigabit Ethernet
/0/100/11 storage SB7x0/SB8x0/SB9x0 SATA Controller [IDE mode]
/0/100/12 bus SB7x0/SB8x0/SB9x0 USB OHCI0 Controller
/0/100/12.1 bus SB7x0 USB OHCI1 Controller
/0/100/12.2 bus SB7x0/SB8x0/SB9x0 USB EHCI Controller
/0/100/13 bus SB7x0/SB8x0/SB9x0 USB OHCI0 Controller
/0/100/13.1 bus SB7x0 USB OHCI1 Controller
/0/100/13.2 bus SB7x0/SB8x0/SB9x0 USB EHCI Controller
/0/100/14 bus SBx00 SMBus Controller
/0/100/14.1 storage SB7x0/SB8x0/SB9x0 IDE Controller
/0/100/14.2 multimedia SBx00 Azalia (Intel HDA)
/0/100/14.3 bridge SB7x0/SB8x0/SB9x0 LPC host controller
/0/100/14.4 bridge SBx00 PCI to PCI Bridge
/0/100/14.5 bus SB7x0/SB8x0/SB9x0 USB OHCI2 Controller
/0/101 bridge Family 10h Processor HyperTransport Configurat
/0/102 bridge Family 10h Processor Address Map
/0/103 bridge Family 10h Processor DRAM Controller
/0/104 bridge Family 10h Processor Miscellaneous Control
/0/105 bridge Family 10h Processor Link Control
wally[~]$
I've been using Lubuntu. So it goes without saying I don't know anything about Linux. That's why I'm back with Salix. Got to start learning sometime.
Thanks for any help rendered.
System freeze problem
Re: System freeze problem
Did you have the same problems with Lubuntu or is it only Salix? Were you actually using that PC before?
It sounds more like a hardware problem.
It sounds more like a hardware problem.
Re: System freeze problem
Gapan, I think it's a driver problem. This didn't happen in Lubuntu and dosen't happen in Slackware 14.2 which I tried for a short while. I still had the network manager problem though. That's why I installed Salix. Salix works great guns on my old Lenovo laptop. Please just suggest some cli commands and strategy I can use to locate the problem.
Thanks for the help.
Thanks for the help.
Re: System freeze problem
Well something must be different. I'm going to research a fix for networkmanager and reload Slackware and see if over time my system locks up. I'll get back to you on this. Thanks.
Re: System freeze problem
For network manager search the forums. There are a few reports that it doesn't work that well with some cards. I think it's usually solved by using a static IP. Or switch to wicd.
Re: System freeze problem
Thanks I'll try those first.
Re: System freeze problem
or netconfig and select DHCPD for wired connection.
Code: Select all
sudo netconfig
Re: System freeze problem
On a fresh install, you should really do a kernel upgrade to the latest kernel from the repositories. Instructions on the wiki. I doubt it'll help with this trouble though.