xsane pas de périphérique
Posted: 13. Nov 2014, 16:57
Bonjour,
Je suis en train d'installer une salix openbox 14.1 en remplacement d'une slackware 14.0, et
ai un probléme avec le scanner de l'imprimante multifonction samsung CLX3175
logiciels installés:
paquet xsane
pilote imprimante ulud_v1.00.06.tar.gz
L'imprimante fonstionne mais pas le scanner, xsane ne trouve pas de périphérique.
l'utilisateur est bien dans le groupe 'scanner'
le commande >sane-find-scanner
J'essaye scanimage -L comme proposé
Comment trouver la cause du probléme.
Merci.
Je suis en train d'installer une salix openbox 14.1 en remplacement d'une slackware 14.0, et
ai un probléme avec le scanner de l'imprimante multifonction samsung CLX3175
logiciels installés:
paquet xsane
pilote imprimante ulud_v1.00.06.tar.gz
L'imprimante fonstionne mais pas le scanner, xsane ne trouve pas de périphérique.
l'utilisateur est bien dans le groupe 'scanner'
le commande >sane-find-scanner
Code: Select all
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
# Also you need support for SCSI Generic (sg) in your operating system.
# If using Linux, try "modprobe sg".
could not open USB device 0x04d9/0xa06b at 004:002: Access denied (insufficient permissions)
found USB scanner (vendor=0x04e8 [Samsung Electronics Co., Ltd.], product=0x342a [CLX-3170 Series]) at libusb:005:003
could not open USB device 0x1d6b/0x0001 at 001:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0001 at 002:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0001 at 003:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0001 at 004:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0002 at 005:001: Access denied (insufficient permissions)
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
# You may want to run this program as root to find all devices. Once you
# found the scanner devices, be sure to adjust access permissions as
# necessary.
Code: Select all
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
Merci.