Je suis en train d'installer une salix openbox 14.1 en remplacement d'une slackware 14.0, et
ai un probléme avec le scanner de l'imprimante multifonction samsung CLX3175
logiciels installés:
paquet xsane
pilote imprimante ulud_v1.00.06.tar.gz
L'imprimante fonstionne mais pas le scanner, xsane ne trouve pas de périphérique.
l'utilisateur est bien dans le groupe 'scanner'
le commande >sane-find-scanner
Code: Select all
# sane-find-scanner will now attempt to detect your scanner. If the
# result is different from what you expected, first make sure your
# scanner is powered up and properly connected to your computer.
# No SCSI scanners found. If you expected something different, make sure that
# you have loaded a kernel SCSI driver for your SCSI adapter.
# Also you need support for SCSI Generic (sg) in your operating system.
# If using Linux, try "modprobe sg".
could not open USB device 0x04d9/0xa06b at 004:002: Access denied (insufficient permissions)
found USB scanner (vendor=0x04e8 [Samsung Electronics Co., Ltd.], product=0x342a [CLX-3170 Series]) at libusb:005:003
could not open USB device 0x1d6b/0x0001 at 001:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0001 at 002:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0001 at 003:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0001 at 004:001: Access denied (insufficient permissions)
could not open USB device 0x1d6b/0x0002 at 005:001: Access denied (insufficient permissions)
# Your USB scanner was (probably) detected. It may or may not be supported by
# SANE. Try scanimage -L and read the backend's manpage.
# Not checking for parallel port scanners.
# Most Scanners connected to the parallel port or other proprietary ports
# can't be detected by this program.
# You may want to run this program as root to find all devices. Once you
# found the scanner devices, be sure to adjust access permissions as
# necessary.
Code: Select all
No scanners were identified. If you were expecting something different,
check that the scanner is plugged in, turned on and detected by the
sane-find-scanner tool (if appropriate). Please read the documentation
which came with this software (README, FAQ, manpages).
Merci.