[solved] zim not working by installing it from Basic

wingevil · Post by **wingevil** » 27. Jul 2010, 13:53

Hi there,

yesterday I installed a new system, starting with the "basic"-choice of installation. After that I installed zim via gslapt. but the start of zim disappears. Here's the info

Any hints to solve the problem are welcome.

Post by **Akuna** » 27. Jul 2010, 15:01

try slapt-get -i pygobject

wingevil · Post by **wingevil** » 27. Jul 2010, 15:24

Akuna wrote:try slapt-get -i pygobject

Unfortunately no solution. There are a new error

Shador · Post by **Shador** » 27. Jul 2010, 15:37

pygtk I reckon

wingevil · Post by **wingevil** » 27. Jul 2010, 15:54

Shador wrote:pygtk I reckon

yepp, You're right! zim starts now

thank you very much

In an older 'full'-install of Salix 13.0, the 'slapt-get'-installation of zim work properly.

And for now I want to avoid the manual installation as I have to do in native slackware...there about more than a dozen pelr-module to be compiled...

Thanks Again!

Post by **gapan** » 27. Jul 2010, 17:28

I added pygtk to the dependencies of zim so this doesn't happen again.

wingevil · Post by **wingevil** » 27. Jul 2010, 17:46

gapan wrote:I added pygtk to the dependencies of zim so this doesn't happen again.

Thank you gapan

[solved] zim not working by installing it from Basic

[solved] zim not working by installing it from Basic

Re: zim not working by installing it from Basic

Re: zim not working by installing it from Basic

Re: zim not working by installing it from Basic

Re: zim not working by installing it from Basic

Re: [solved] zim not working by installing it from Basic

Re: [solved] zim not working by installing it from Basic