Page 1 of 1
[solved] zim not working by installing it from Basic
Posted: 27. Jul 2010, 13:53
by wingevil
Hi there,
yesterday I installed a new system, starting with the "basic"-choice of installation. After that I installed zim via gslapt. but the start of zim disappears. Here's the info
Any hints to solve the problem are welcome.
Re: zim not working by installing it from Basic
Posted: 27. Jul 2010, 15:01
by Akuna
try slapt-get -i pygobject
Re: zim not working by installing it from Basic
Posted: 27. Jul 2010, 15:24
by wingevil
Akuna wrote:try slapt-get -i pygobject
Unfortunately no solution. There are a new error
Re: zim not working by installing it from Basic
Posted: 27. Jul 2010, 15:37
by Shador
pygtk I reckon
Re: zim not working by installing it from Basic
Posted: 27. Jul 2010, 15:54
by wingevil
Shador wrote:pygtk I reckon
yepp, You're right! zim starts now
thank you very much
In an older 'full'-install of Salix 13.0, the 'slapt-get'-installation of zim work properly.
And for now I want to avoid the manual installation as I have to do in native slackware...there about more than a dozen pelr-module to be compiled...
Thanks Again!
Re: [solved] zim not working by installing it from Basic
Posted: 27. Jul 2010, 17:28
by gapan
I added pygtk to the dependencies of zim so this doesn't happen again.
Re: [solved] zim not working by installing it from Basic
Posted: 27. Jul 2010, 17:46
by wingevil
gapan wrote:I added pygtk to the dependencies of zim so this doesn't happen again.
Thank you gapan
