How to connect huawei e303 gsm modem on salix 14?

[danoe]

i have salix 14 on my pc. I try to connect this modem with sakis3g and doesn't work. Previously I have linux mint on my pc. In linux mint, plug this modem, type 192.168.1.1 on web browser, click connect on the web page interface, and i get internet access.

I found this thread via google
http://www.draisberghof.de/usb_modeswit ... f=4&t=1021
forums.opensuse.org/english/get-technical-help-here/478580-huawei-e303-12-2-driver-install-usb-switch-happens-cdc_ether-runs-but-no-internet.html
help me..

[danoe]

Please guide me step by step to solve this problem. I am very newbie in linux and need some guides to use terminal or edit .conf file

[danoe]

Sorry for my bad english

[mimosa]

I'm afraid I can't help with your specific problem, but as you say you might need help with using terminal, I wonder if you've had a look at the Salix User Guide, available in a number of languages:

http://www.salixos.org/wiki/index.php/S ... rtup_Guide

Somewhere around Chapter Four is a section on getting started with the command line.

Also, do search the forum and look at the Salix wiki, if you haven't already. http://www.linuxquestions.org is a very good general site.

Finally, it will help people to help you solve your problem if you are as specific as possible about what you tried and what happened. "Doesn't work" is not very informative.

A lot of users have had similar problems, and the Sakis 3g script works for some cases. This may not be an easy problem to solve. There is no step by step guide - it's a question of working out what to do.

Good luck!

[gapan]

I try to connect this modem with sakis3g and doesn't work.

How?

[danoe]

Open terminal, su, sakis3g, connect with 3g, usb device. My modem detected as huawei hilink, i choose that,
locating device. . .
locating tty. . .
failed to connect
i also switch modem with sakis 3g and modem switched. Try to connect again but still failed.
lsusb id is 12d1:14db

[slack631]

HI

Install ModemManager and mobile-broadband-provider-info packages
enable rc.networkmanager
then run

Code: Select all

nm-connection-editor

You can download and install manualy from here; or some other mirror,for 32bit,:
ftp://ftp.osuosl.org/pub/slackware/slac ... ackware/n/

regards

[danoe]

download modemmanager, mobile broadband provider, networkmanager, networkmanager applet .txz file. And then install with spkg -i, go to system-->system service mark networkmanager and unmark wicd, go to settings-->session&startup and unmark wicd, reboot, DONE !! thanks for all

[jayseye]

Ready to mark this thread [Solved] then, by pre-pending that term to the Subject?

[Andyun]

See Huawei E-173.